FS Screed - Heavy Duty Epoxy Floor Screed
Far stronger than concrete, FS Screed has been developed to take heavy wear in industrial and civil engineering environments. For reinstatements and repairs, this system outperforms conventional screeds.
For more information on this product please download the datasheet(s) below:
Click on the section below to read further information.
To complete the clause, select the appropriate wording from below. You can highlight the text to copy and paste it into your documents to save typing.
M12 RESIN FLOORING
10 RESIN FLOORING:
Conren FS Screed
A heavy duty, epoxy resin floor screed designed to provide maximum resistance to wear in industrial environments. The screed is designed to be laid on a variety of floor substrates and, when sealed, is completely impervious and resistant to most chemicals, acids, alkalis and solvents. It is many times stronger than concrete and is also designed for civil engineering projects and as a repair mortar for structural concrete.
Where non-slip finishes are required, Conren Congrip may be applied onto the FS Screed: see technical information in this section.
Application thickness: Any depth down to a feather edge.
Colours: 4 standard colours are available. FS Screed can also be sealed with various Conren coatings to extend the colour range – see M60/110.
Conren recommend mechanical preparation for most substrates prior to installation of epoxy resin coatings/screeds and offer a range of primer systems to suit most situations.
Where the moisture content in a new concrete slab exceeds 75% RH, e.g. in fast track construction projects, Conren WD Aquatect, water vapour suppressant/primer should be used. Consult Conren for recommendations and details.
Existing surfaces must be clean, dry and free from contamination which can prevent the effective adhesion of coatings and screeds. For heavily oil contaminated surfaces, the concrete should be shotblasted and subjected to hot compresses air (HCA) followed by a holding primer of WD Bonder or WD Aquatect. Consult with Conren for full details.
Most epoxy and polyurethane systems can be applied to timber surfaces, metal structures and other substrates. It is recommended to consult Conren’s Technical Sales Department for the recommended preparation requirements for individual projects. Add additional preparation requirements to clause 110 or amend clauses 210-260 as necessary.
It is important that movement joints are incorporated throughout the entire floor system and Conren also produce Flexijoint, a joint system to suit all manner of construction methods, including crack induced/sawn joints and pre-formed expansion joints as well as coved skirting details and other finishing requirements.
Conren will carry out site surveys and offer technical advice on the use and performance of all Conren products. A maintenance range of products is available for end user application.
Consult Conren Ltd technical literature for details. Conren Ltd can also provide a design and specification service and it is recommended that they are consulted early in the design process.
10 RESIN FLOORING:
Preparation: As clauses 230, 240 and 310. Consult Conren for additional advice on preparing contaminated surfaces or dealing with fast track application on new concrete.
Resin flooring system:
Manufacturer: Conren Limited, Unit 1, The Bridge Business Centre, Ash Road South, Wrexham Industrial Estate, Wrexham LL13 9UG. Tel: 01978 661 991 Fax:01978 664 664. Email: email@example.com Web: www.conren.com
Primer reference: Primer ‘S’ to weak or friable surfaces
Resin flooring reference: FS Screed
Application: Consult with Conren Ltd for recommendations and details.
Nominal thickness: FS Screed can be laid in thicknesses from 3mm to 20mm. Consult with Conren Ltd for recommendations and details.
Colour: Light Grey / Dark Grey / Light Stone / Tile Red
Surface finish/treatment: Consult with Conren Ltd for recommendations and details.
Resin skirtings/upstands: Consult with Conren Ltd for recommendations and details.